SETSIZE
setsize will set the mesh object attributes xmin,xmax,ymin,ymax,zmin,zmax from the xic,yic,zic values of all 'real' points (dudded and merged points will be ignored).  It also sets epsilon, epsilona and epsilonv as follows:  setsize is called internally by LaGriT commands that add nodes to the mesh;copypts, createpts, regpnts, recon,scale, translate
epsilonv=abs(xmax-xmin)*abs(ymax-ymin)*abs(zmax-zmin)*epsilonr*1000.
epsilona=((xmax-xmin)**2+(ymax-ymin)**2+(zmax-zmin)**2)*epsilonr*1000.
epsilonr is set at initialization time by:
x2=one
do i=1,1000
x2=x2/two
x1=one+x2
if(x1.le.one) go to 11
enddo
11 epsilonr=x2*2.
where the values of 'one' and 'two' are obtained from the include file 'consts.h'.
The command cmo/printatt can be used to view any of these cmo attributes:
e.g. cmo/printatt//xmax
The programmer interface is the subroutine setsize (see Section e.7)
The variables epsilonl, epsilona and epsilonv are mesh object attributes; hence they may be different for all meshes in a given run.  epsilona, epsilonv and epsilon1 may be set by the user with the cmo/setatt command.  They also will be written to LaGriT dumps and subsequently will be read in at restart. The variables in consts.h (epsilon and epsilonr) are machine and run dependent. They are not written to LaGriT dumps and there is only one copy per run.
 
FORMAT: setsize
if epsilonv is very small epislonvis set to epsilona
epsilon1 is set by a call to set_epsilon
epsilon1 is set to the square root of epsilona unless this number would be too small in which case epsilon1 is to (( xmax-xmin) + (ymax-ymin) + (zmax-zmin)) * 1.e=8/3

Many LaGriT algorithms use epsilon1; for example, if a node falls on a interface or boundary surface.  It uses epsilonv to determine if a node can be connected.  Errors from setpts and connect may result if inconsistant or wrong values of epsilons are used.